I've starting to get this error email since last night (3 times):QuoteHi,
The Acu-Link service cloud has not received a message from your Three in One sensor for one hour. You may need to replace the batteries or relocate the sensor within 330 feet of the Acu-Link enabled bridge device.
The batteries in the 3 in 1 and rain gauge are only 2 weeks old (Duracell's with a 2024 best before date) and none of the hardware has been relocated recently, the whole setup is 2 weeks old. I add the Kevin's weather bridge stuff a week ago, and al seems ok til these error message started showing up yesterday.
Looking at 'my back yard' is see the forecast is blank now because of lack of history, but both PWSweather and weather underground seem to have history for that time.
http://www.wunderground.com/personal-weather-station/dashboard?ID=IONTARIO952
http://www.pwsweather.com/obs/LDNONZUG.html
Looking at the 3 error emails from MBY, they came in 11:13pm, 9:12am, and the last one at 12:12pm, which seems interesting they are all about the same time after the hour.
The PC running the bridge is a Pentium 4, 2.4GH, Windows XP Pro. which all is running BONIC (seti@home) and bfminer which seem to be running normally. I've just rebooted the PC to see if that helps, but was wondering if anybody has run in to anything like this?
as a side note, I've noticed some times peek wind speeds on WU and PWSW are higher then my display shows for peeks.. WU shows gust 32, and 20 currently while the desk display says 15 and peek 17 mph
You do have some lengthy gaps showing up on wunderground and pwsweather today. They're the very flat horizontal lines. I assume Kevin's program continues to send the last good data it had.
Based on the error message from MBW, it sounds like the problem is in the 3n1, but I'd check MBW and see if the barometer and rainfall sensor continue to report in regularly.
My initial guess is that this problem has nothing to do with your PC or Kevin's program. If you figure out why MBW isn't happy and correct it, everything else will fall back into place.
Is the 3n1 sensor coming back on its own, or are you doing something to make it report again?