I totally gave up on getting an Acurite - pun intended! ![:)]( "Smile")
- barometric pressure reading from my beloved 5-in-1 and I will probably break down and buy a new bridge since that seems to be the culprit - i mean after calling and seeing if I can get it replaced on warranty anyways.
I have tried re-calibrating it multiple times (i.e totally resetting both monitor and bridge when the pressure is the recommended 29.92).
The console reading is always close to being accurate but the bridge is always ridiculously off, has been since I got it. What's totally weird is when I was actually trying to report b/p to WU I would see yet a different number that was close to being right but not quite, A console number, a bridge # and a third one on WU. I totally didn't get that.
I resolved it by not sharing b/p with WU anymore and removing it from the AcuLink dashboard.
It doesn't work if you the use Acurite adjusted, the absolute or even a correction to absolute. It can't even stay stable enough for the correction to absolute to stay consistent.
If there was a way to report it from the console's readings instead of the bridge that would be at least closer to being correct. The consoles b/p is at least reasonably close but still off .07 too high (29.98 om AcuBridge, 29.91 Davis Vue and VP2 w/24hr FARS) but at least it's not off by 10-15 pt high/low like the bridge.
- barometric pressure reading from my beloved 5-in-1 and I will probably break down and buy a new bridge since that seems to be the culprit - i mean after calling and seeing if I can get it replaced on warranty anyways.I have tried re-calibrating it multiple times (i.e totally resetting both monitor and bridge when the pressure is the recommended 29.92).
The console reading is always close to being accurate but the bridge is always ridiculously off, has been since I got it. What's totally weird is when I was actually trying to report b/p to WU I would see yet a different number that was close to being right but not quite, A console number, a bridge # and a third one on WU. I totally didn't get that.
I resolved it by not sharing b/p with WU anymore and removing it from the AcuLink dashboard.
It doesn't work if you the use Acurite adjusted, the absolute or even a correction to absolute. It can't even stay stable enough for the correction to absolute to stay consistent.
If there was a way to report it from the console's readings instead of the bridge that would be at least closer to being correct. The consoles b/p is at least reasonably close but still off .07 too high (29.98 om AcuBridge, 29.91 Davis Vue and VP2 w/24hr FARS) but at least it's not off by 10-15 pt high/low like the bridge.